Thread Closed 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1990 lebaron
12-09-2007, 02:29 AM
Post: #1
1990 lebaron
Replacing a cv joint on drivers side. Oil seal is out of the tranny but there seems to be another seal or something there. It looks like a easy fix but I am not sure. Any ideas
Find all posts by this user
12-09-2007, 03:01 PM
Post: #2
RE: 1990 lebaron
Did one of those not too long ago and only recall a single seal on both sides.

Perhaps you didn't get all of the pieces out? The old seal is rubber on the inside diameter and a coated steal for the outside perimeter. Quite often it breaks into pieces on removal.

If you removed several bolts and took the side of the trans case off in the process (not necessary) you should be looking at an o-ring or silicone sealer on that mating surface.

When you re-install the axel be sure you hear the snap-ring (on the axel) click into place before installing the outter end to the wheel hub. Normally it will require several firm pushes with a quarter turn each time to get the ring centered before it goes fully into position. Jack up the other side and put the trans into neutral to make this easier.

Rupe
Find all posts by this user
12-09-2007, 03:05 PM
Post: #3
RE: 1990 lebaron
Click here and there is info on your car. It should show what you want to know. Good luck.

Being way2old is why I need help from younger minds.

Visit here to see our surplus vehicles.

[Image: crybaby.jpg]
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)